Bathroom Electrics: Zones, Ratings and Why They Matter
Bathrooms have the strictest electrical requirements in a home, for the most obvious reason.
Bathrooms are where the electrical rules are tightest, and the reason is not bureaucratic. Water reduces the resistance of the human body dramatically, which means a fault that would give an unpleasant shock in a hallway can be lethal in a bathroom.
The zone system
Bathrooms are divided into zones based on proximity to water, and each zone permits different equipment.
Zone 0 — inside the bath or shower basin itself. Only equipment specifically designed for immersion, at very low voltage.
Zone 1 — directly above the bath or within the shower enclosure, up to 2.25m. Equipment must be rated for the exposure, and only certain types are permitted.
Zone 2 — extending 0.6m beyond zone 1. Requirements are less stringent but still specific.
Outside the zones — the rest of the room, where general requirements apply, though the room as a whole still carries additional protective requirements.
IP ratings
An IP rating has two digits: protection against solids, then against water.
The second digit is what matters in a bathroom. IPX4 means protection against splashing from any direction — the common minimum for zones 1 and 2. IPX7 means protection against temporary immersion.
A fitting with no water rating at all, installed above a shower, is not a technicality. It is a genuine hazard, and it is one of the more common things we find in bathrooms that have been altered by someone unfamiliar with the requirements.
No sockets
Standard sockets are not permitted in bathrooms, other than shaver supply units and, beyond a defined distance from the bath or shower, in larger rooms.
This surprises people who have seen sockets in bathrooms abroad. The UK approach is more restrictive, deliberately.
RCD protection
Circuits serving a bathroom require RCD protection. This is not optional, and in a property with an older board it is frequently one of the reasons a board upgrade becomes necessary before bathroom work can proceed.
Bonding
Supplementary bonding — connecting metal pipework and fittings together — may be required depending on the installation. Whether it is needed depends on the circuits serving the room and the protective measures in place, which is a matter for testing rather than assumption.
Electric showers
An electric shower needs its own high-current circuit from the board with appropriate protection and a suitably rated isolator, usually a ceiling-mounted pull cord.
It is one of the heaviest single loads in a domestic property, and the questions that decide the job are whether the board has a spare way and whether the supply comfortably supports it.
Notifiable work
Adding or altering circuits in a room containing a bath or shower is notifiable under the Building Regulations. This is one of the categories that catches people out, because it applies even to work that feels minor.
Extraction
Bathrooms need mechanical extraction where there is no openable window, and it is a good idea regardless. Usually a fused connection with overrun, and worth planning alongside the lighting rather than afterwards.
Planning a bathroom
Bring us the layout before first fix. The zones follow from where the bath and shower actually go, so the electrical design cannot sensibly precede that decision.
Keep reading
Related guides
Domestic Electrical Safety: What to Check at Home
A short, practical list of things worth noticing in your own home — none of which require tools or any risk to you.
Common Electrical Problems in London Homes
London’s housing stock produces a recognisable set of electrical problems. Here are the ones we see most often, and why.
Electrical Considerations Before a Loft Conversion
Loft conversions run into the same electrical surprise again and again — and it is one that is much cheaper to find at design stage.