Common Electrical Problems in London Homes
London’s housing stock produces a recognisable set of electrical problems. Here are the ones we see most often, and why.
London's housing is unusually varied, and the electrical problems that come with it are surprisingly predictable once you know what the building is. A Victorian terrace, an inter-war semi and a converted warehouse each produce their own characteristic set of faults.
Victorian and Edwardian terraces: layers of alteration
These houses were not wired at all when they were built. Electricity arrived later, and has been added to repeatedly since — often by different people, at different times, to different standards.
The result is installations where circuits take unexpected routes, where junction boxes sit in inaccessible places, and where nobody can say with confidence what feeds what. That matters, because any significant work has to start by establishing what is actually there.
The associated problem is capacity. A house wired for a handful of circuits now runs a kitchen full of appliances, a home office and a car. The board is frequently the constraint.
Flat conversions: who owns which circuit?
An enormous amount of London housing is flats within converted houses, and the conversions vary from excellent to alarming.
The recurring issue is the boundary: which circuits belong to which dwelling, where the communal installation ends, and whether the supply arrangement is what the paperwork says it is. In older conversions this is often undocumented.
It has to be established before any board work, and it is not unusual for the investigation to take longer than the job it precedes.
Inter-war semis: original boards, modern demands
The 1930s expansion that built much of outer London — Enfield, Barnet, Harrow, Bexley, Redbridge — produced housing of broadly consistent construction. Consistently, a lot of it still has consumer units installed decades ago.
These properties also tend to have off-street parking, gardens and outbuildings, which means EV chargers, garden office supplies and outdoor lighting. All of which need circuits a full board cannot provide.
Warehouse conversions: an inherited installation
Converted industrial buildings in Hackney, Tower Hamlets and Southwark carry electrical inheritance: three-phase supplies sized for machinery, boards positioned for a factory floor, and cabling of uncertain vintage.
The recurring problem is that the installation bears little relation to how the space is now used. Surveying what is actually there, before planning anything, routinely changes the answer.
New-build apartments: modern, managed, constrained
The installations are modern and usually well documented, so faults are less common. The constraints are different: almost any alteration needs building management agreement, access to risers is controlled, and working hours are restricted.
The work is straightforward; the process around it is not.
The problems that cross all of them
- No RCD protection. Common in any property whose board has not been touched in decades.
- Full boards. The single most common reason a simple addition becomes a two-part job.
- Extension leads in permanent use. Always a sign the room needs more sockets.
- Outdoor circuits without adequate protection. Particularly supplies to sheds and garages added informally.
- Bathroom and kitchen work that predates current requirements. These are the areas where standards have tightened most.
What to do about it
If your property is any of the above and you do not know when the installation was last inspected, that is the place to start. An inspection establishes condition, which is the only basis on which sensible decisions about the rest can be made.
We work across London — see the areas we cover — and are based in Enfield.
Keep reading
Related guides
Domestic Electrical Safety: What to Check at Home
A short, practical list of things worth noticing in your own home — none of which require tools or any risk to you.
Electrical Considerations Before a Loft Conversion
Loft conversions run into the same electrical surprise again and again — and it is one that is much cheaper to find at design stage.
Electrical Maintenance Tips for Landlords
Letting property brings specific electrical duties. Handling them proactively is considerably cheaper than handling them reactively.