Frequently asked questions
Faults and repairs
Tripping circuits, dead sockets, flickering lights and fault finding.
Three common causes: an overloaded circuit, a short circuit, or earth leakage. A breaker that trips once and resets cleanly may have been a one-off — an appliance failing, for instance. One that trips repeatedly is reporting a fault, and resetting it repeatedly is not a fix.
Related: Electrical Services
Unplug everything on the affected circuits, reset the RCD, then reconnect items one at a time, leaving a gap between each. If it trips when a particular appliance is reconnected, that appliance is the likely culprit. If it trips with nothing connected, the fault is in the fixed wiring and needs investigating.
Related: Electrical Services
With LED fittings, most often a dimmer and driver that are not compatible. Otherwise, a loose connection somewhere in the lighting circuit — which is worth taking seriously, because loose connections generate heat. Flickering across the whole property rather than one circuit can indicate a supply issue.
Related: Electrical Services
Often, yes — a failed accessory or a loose connection at that point. But a dead socket can also be the visible end of a fault further back in the circuit, particularly on older ring circuits. Testing establishes which, and that determines the job.
Related: Electrical Services
Fault finding is the diagnostic work of locating a fault: isolating circuits, testing insulation resistance and continuity, and narrowing down methodically. It is skilled work that takes time and is genuinely separate from the repair, because until the fault is found nobody knows what the repair is.
Related: Electrical Services
Yes, but intermittent faults take longer. The pattern is the useful clue — whether it happens in wet weather, at a particular time, or when a specific appliance runs. Keep a note of when it trips before we visit; it frequently narrows the search considerably.
Related: Electrical Services
Look at the consumer unit: an RCD covering one side of the board will take out several circuits at once. If it will not reset, there is a fault on one of those circuits. Also check whether neighbours have power — if not, it is a supply issue rather than your installation.
Related: Electrical Services
A wider outage is the responsibility of the distribution network operator, not an electrician. In Great Britain you can call 105 free from most phones and be connected to the relevant network operator for your area.
Related: Electrical Services
Repeated early failures in the same fitting usually point to a problem with the fitting or the connection rather than the bulbs. Heat is a common factor — enclosed fittings shorten LED life considerably. Failures across the whole property can indicate a supply voltage issue.
Related: Electrical Services
No. A consumer unit should be silent. Buzzing or humming can indicate a loose connection or a device that is failing, and both deserve prompt attention. Do not ignore it because everything still works — connections that generate heat are exactly how electrical fires begin.
Related: Electrical Services
Water and electricity need separating before anything else happens. Isolate the affected circuits, deal with the water, and let things dry before testing. Accessories and cable that have been wet frequently need replacing rather than drying out — testing establishes what survived.
Related: Electrical Services
Yes, and it is common. Where we find work that does not meet standards, we will tell you what is wrong and what it would take to put right. We will not, however, certify somebody else's installation as though we had carried it out.
Related: Electrical Services
Call us
Speak to an electrician
Describe the fault or the job and we will tell you what is involved.
Keep exploring
Where to next
- All electrical services Installation, repairs, CCTV, fire alarms, lighting, EV charging and consumer units.
- Areas we cover Thirty-three London boroughs, each with its own page.
- Guides and advice Fifty practical articles for homeowners, landlords and businesses.
- Project gallery Examples of the work, by type.