Frequently asked questions
CCTV and security
Camera systems, coverage, recording and the rules that apply.
Fewer than most people expect, positioned better than most systems are. Four well-placed cameras will tell you more than twelve installed without a plan. The number follows from what you need to see — identification at entry points is a different requirement from general area coverage.
Related: CCTV Installation
At the points where someone actually approaches, at a height where a face is captured rather than the top of a head. Mounting cameras high and looking down is common and produces footage in which nobody can be identified — which defeats the purpose of having them.
Related: CCTV Installation
For a permanent installation, wired is generally more reliable: no dependency on wireless signal quality, and power and data in one run. Wireless has its place where cabling is genuinely impractical, but it introduces failure modes a hard-wired system does not have.
Related: CCTV Installation
Only as long as there is a reason to keep it. Retention should be proportionate to the purpose — commonly a few weeks for general security. Keeping footage indefinitely creates a data protection liability without adding much practical benefit.
Related: CCTV Installation
Yes, remote viewing is standard on modern systems. The thing worth insisting on is that the default password is changed during setup — unchanged default credentials are the single most common weakness in domestic and small commercial CCTV, and remotely accessible cameras are actively scanned for.
Related: CCTV Installation
If your system captures areas beyond your own property boundary, data protection obligations apply and signage is part of that. For commercial premises the requirements go further. We will flag where this is likely to apply, but you should take your own advice on compliance.
Related: CCTV Installation
It can, but doing so brings your system within UK GDPR, with obligations including signage and responding to requests for footage. On terraced and semi-detached streets this comes up more often than people expect, and it is worth taking into account when positioning cameras.
Related: CCTV Installation
Frequently, yes, and existing cable routes can often be reused — which keeps both disruption and cost well below a fresh installation. Where a system is old enough that the cabling itself is the limitation, we will tell you rather than fitting new cameras onto infrastructure that cannot support them.
Related: CCTV Installation
Modern cameras handle low light well, but "works at night" varies enormously with the position. Infrared illumination has a limited effective range, and a camera pointing towards a bright light source will struggle regardless of specification. Night performance is a positioning question as much as a camera one.
Related: CCTV Installation
At least annually. Cameras drift out of alignment, lenses get dirty, seals degrade and hard drives fail — usually silently. A system nobody has checked for two years is quite often not recording at all, which is discovered at precisely the wrong moment.
Related: CCTV Installation
The recorder needs a supply, and cameras are typically powered over the same cable that carries their data. The practical considerations are where the recorder lives, whether it is somewhere secure, and whether it is protected against losing power at the moment it matters.
Related: CCTV Installation
Call us
Speak to an electrician
Describe the fault or the job and we will tell you what is involved.
Keep exploring
Where to next
- All electrical services Installation, repairs, CCTV, fire alarms, lighting, EV charging and consumer units.
- Areas we cover Thirty-three London boroughs, each with its own page.
- Guides and advice Fifty practical articles for homeowners, landlords and businesses.
- Project gallery Examples of the work, by type.