Frequently asked questions
Consumer units and fuse boxes
Board replacement, RCDs, tripping and electrical safety upgrades.
They are the same thing. "Fuse box" is the everyday term and "consumer unit" is the technical one. Both describe the board where the incoming supply is divided into circuits and protected. What has changed over the decades is how much protection that involves.
Rewirable fuses rather than circuit breakers, a wooden back box, no RCD protection at all, repeated unexplained tripping, any sign of heat damage or discolouration, no spare ways when you need to add a circuit, or an inspection report with observations about the board. Any of those is worth a conversation.
No. Age alone does not make a board unsafe, and replacing one in sound condition purely because it is old is not always necessary. What matters is its condition, the protection it provides and the state of the installation behind it. That is an assessment, not a rule of thumb.
Typically a day for a straightforward domestic board, including the testing before and after. It takes longer where circuits need tracing, where faults are found during the pre-replacement testing, or where the board is being relocated. We would rather give you a realistic figure than an optimistic one.
Because a new board with sensitive RCD protection will immediately reveal faults that an old board tolerated silently — most often deteriorated insulation in older wiring. Finding those first is what prevents the situation where a brand new consumer unit will not stay switched on.
Yes, for most of it. The supply has to be isolated while circuits are transferred to the new board. We will tell you in advance roughly how long that will be so you can plan around it — particularly important if you work from home or have anything that cannot lose power.
Often, yes. Boards in under-stairs cupboards or awkward corners are common in older property, and relocation is worth considering if the board is being replaced anyway. It adds work, because the tails and every circuit have to reach the new position, so it is a decision to make at the outset.
Yes. Consumer unit replacement in a dwelling in England and Wales is notifiable under the Building Regulations, and the installation must be certified. [INSERT INFORMATION] — the company's competent person scheme registration should be confirmed and stated here.
Sometimes, with a smaller board added alongside for the new circuit. Whether that is the sensible answer depends on the age and condition of the existing board — if it was heading for replacement anyway, doing it once is usually better than doing it twice.
An SPD limits voltage spikes reaching the installation, typically from lightning activity or supply switching. Whether one is required depends on the property and the risk assessment. They are more commonly fitted now than they once were, particularly where there is expensive connected equipment.
Consumer units in domestic premises are now generally required to have a non-combustible enclosure, which in practice means metal. This followed a pattern of fires originating in plastic boards. An existing compliant plastic board does not have to be replaced solely for that reason.
Call us
Speak to an electrician
Describe the fault or the job and we will tell you what is involved.
Keep exploring
Where to next
- All electrical services Installation, repairs, CCTV, fire alarms, lighting, EV charging and consumer units.
- Areas we cover Thirty-three London boroughs, each with its own page.
- Guides and advice Fifty practical articles for homeowners, landlords and businesses.
- Project gallery Examples of the work, by type.