Winter Electrical Problems and How to Avoid Them
Cold, wet weather produces a predictable seasonal pattern of electrical faults. Most of them are avoidable.
Electrical call-outs follow the seasons, and winter has a recognisable profile. The faults are not random — they are the predictable consequence of cold, wet weather meeting installations with pre-existing weaknesses.
Moisture in outdoor circuits
The most common winter fault by a distance. Outdoor sockets, garden lighting, supplies to sheds and garages — all of them exposed to sustained rain and freeze-thaw cycling.
Perished seals, cracked enclosures and cable damage let water in. Water causes earth leakage. Earth leakage trips the RCD, usually at night, usually in the rain.
Prevention: inspect outdoor enclosures before winter. Check seals are intact, glands are tight and enclosures are not cracked. It is a fifteen-minute job in October that prevents a bad evening in January.
Heating load
Electric heaters are among the heaviest domestic loads, and in winter several may run simultaneously. Circuits that are comfortable in summer become marginal.
The classic failure is a portable heater on an extension lead — particularly a coiled one, which can overheat inside the coil even though nothing looks wrong from outside.
Prevention: plug heaters directly into wall sockets, never into extension leads, and never into multiway adaptors shared with other loads.
Condensation
Cold surfaces and warm moist air produce condensation, and it finds its way into places water was never expected — outdoor enclosures, unheated outbuildings, garages, loft spaces.
It causes the same earth leakage faults as rain but is harder to diagnose, because there is no obvious water.
Christmas lighting
A genuine seasonal category. Outdoor decorative lighting is frequently rated for indoor use, connected with indoor extension leads, and left out in the weather for six weeks.
Prevention: use fittings rated for outdoor use, connect them through outdoor-rated equipment, and ensure the circuit has RCD protection. A permanent outdoor socket, properly installed, is a better answer than a lead through a window that will not quite close.
Frozen and damaged supplies
Buried cable to outbuildings can be damaged by ground movement in freeze-thaw conditions, particularly where it was installed at inadequate depth.
This shows as an intermittent fault that correlates with the weather — the classic signature of an underground supply problem.
Storm damage
Overhead supplies, external lighting and rooftop equipment are all exposed. After a significant storm it is worth looking at external electrical equipment for visible damage.
Do not touch anything that looks damaged, particularly if it belongs to the network operator. Call 105.
Darkness and lighting
Not a fault, but a seasonal issue. Failed external lighting matters far more in December than in June, and steps, paths and entrances that are adequately lit in summer become genuine hazards in winter.
Check outdoor lighting before the clocks change rather than after. See our lighting page.
A short pre-winter check
- Inspect outdoor enclosures, seals and glands.
- Test the RCD.
- Check external lighting works and is aimed usefully.
- Remove extension leads currently supplying anything outdoors.
- Check heaters are plugged directly into sockets.
Half an hour, and it prevents most of the list above.
Keep reading
Related guides
Why Does My Circuit Breaker Keep Tripping?
A breaker that trips is doing its job. Understanding which of three faults it is reporting tells you how seriously to take it.
What an EICR Is, and What the Codes Actually Mean
Electrical Installation Condition Reports are full of codes that decide whether you have a problem. Here is how to read one.
When Should You Call an Electrician?
Some electrical problems can wait. Some genuinely cannot. Here is a practical way to tell which is which.