Skip to main content
BeydilliBright
Call
Commercial

Office Electrical Installations: Planning for How People Work

Office layouts change more often than office wiring does. Designing for that is mostly about where power comes out of the floor.

BeydilliBright Ltd. 3 min read
An open-plan ground floor during refurbishment, with a linear wall light, pendant fittings and a fabric shade lit for the first time beside a glazed internal door and staircase

The defining characteristic of an office is that its layout changes and its wiring does not. Desks move, teams grow, departments reorganise — and the electrical installation, designed around one arrangement, becomes progressively less suitable for the next.

Good office electrical design is mostly about anticipating that.

Power where people sit

Wall sockets are useless in an open-plan office, because desks are not against walls. Power has to reach the middle of the floor, which means floor boxes, poke-throughs, or power delivered through furniture.

The decision that matters is density. Floor boxes at a spacing that suits today's layout will not suit tomorrow's. A slightly more generous grid costs relatively little at installation and saves a great deal at the first reorganisation.

Power and data together

Almost every desk needs both, so they should be planned and installed together. Retrofitting data into an installation that only anticipated power is disruptive and usually produces a worse result.

The comms cabinet also needs thinking about: dedicated circuits, adequate ventilation, and a position that is secure and accessible. Cabinets in cupboards with no airflow are a recurring cause of equipment failure.

Lighting

Office lighting has to provide appropriate light levels for the work, avoid glare on screens, and — in premises lit for long hours — not cost a fortune to run.

Worth considering:

  • Presence detection in meeting rooms and circulation areas, where lights are routinely left on in empty spaces.
  • Daylight-linked dimming near windows.
  • Zoning that allows part of a floor to be lit for late working without lighting all of it.
  • Separate treatment for meeting rooms, which need to be dimmable for presentations.

Meeting rooms

Consistently under-specified. A meeting room needs power and data at the table, not just at the walls, provision for a display and its associated equipment, and lighting that can be dimmed without flicker.

Rooms where the only power is a socket by the door end up with cables across the floor, which is both a trip hazard and a visible sign of a room that was not thought about.

Emergency lighting and escape routes

Emergency lighting must cover escape routes as they actually are. After a reconfiguration, escape routes frequently move and the emergency lighting does not follow.

This is one of the most common compliance gaps we find in offices, and it is entirely a consequence of treating reconfiguration as a furniture exercise.

Capacity for the future

Offices tend to accumulate equipment. Leaving spare ways at the distribution board and spare capacity in containment is inexpensive at installation and valuable later.

Working around occupation

Most office electrical work happens in occupied buildings, which means evenings, weekends, and phased work floor by floor. That is a programming question, and it belongs in the plan from the start.

See our commercial electrical services page.

Keep reading

Related guides

Call us

Speak to an electrician

Describe the fault or the job and we will tell you what is involved.

07832450917 Request a quote