Enfield
Consumer Unit Replacement in Enfield
Fuse box and consumer unit installation, replacement and upgrades across Enfield — the most common electrical safety improvement in the borough’s older housing.
Consumer unit replacement is the single most common piece of electrical safety work we carry out in Enfield, and the reason is the borough's housing stock.
Why it comes up so often here
Much of Enfield was built between the wars, and a large number of those properties have had the same consumer unit for decades. Boards with rewirable fuses, or with circuit breakers but no RCD protection, are still common across Bush Hill Park, Grange Park, Palmers Green and the older parts of Edmonton.
An older board is not automatically dangerous. What it does not do is disconnect the supply when current leaks to earth — and that is the fault that matters when a person is involved. That is the gap a modern consumer unit closes.
Testing first, replacing second
The part of this job that gets skipped elsewhere is the testing beforehand. A new board with sensitive RCD protection will immediately reveal faults that an old board tolerated silently for years — most often deteriorated insulation in older wiring, which is exactly what you would expect in a property of this age.
Finding those faults before the board is changed is what stops the situation where a new consumer unit will not stay switched on. In properties of Enfield's typical vintage, this step matters more than average.
When a board change is not the whole answer
Occasionally the testing shows that the wiring behind the board has deteriorated to the point where replacing the board alone is not sufficient. We would rather tell you that before the work than halfway through it, and we will set out what the options are.
Straightforward upgrades
Not every job needs a full replacement. Adding a way for a new circuit, or improving the protection on a specific circuit, is sometimes all that is required — and where that is the case we will say so.
Have a look at your board
A photograph of your consumer unit is usually enough for us to tell you whether it is worth discussing. Send one, or call 07832450917.
Common questions
They are the same thing. "Fuse box" is the everyday term and "consumer unit" is the technical one. Both describe the board where the incoming supply is divided into circuits and protected. What has changed over the decades is how much protection that involves.
Rewirable fuses rather than circuit breakers, a wooden back box, no RCD protection at all, repeated unexplained tripping, any sign of heat damage or discolouration, no spare ways when you need to add a circuit, or an inspection report with observations about the board. Any of those is worth a conversation.
No. Age alone does not make a board unsafe, and replacing one in sound condition purely because it is old is not always necessary. What matters is its condition, the protection it provides and the state of the installation behind it. That is an assessment, not a rule of thumb.
Typically a day for a straightforward domestic board, including the testing before and after. It takes longer where circuits need tracing, where faults are found during the pre-replacement testing, or where the board is being relocated. We would rather give you a realistic figure than an optimistic one.
Because a new board with sensitive RCD protection will immediately reveal faults that an old board tolerated silently — most often deteriorated insulation in older wiring. Finding those first is what prevents the situation where a brand new consumer unit will not stay switched on.
Yes, for most of it. The supply has to be isolated while circuits are transferred to the new board. We will tell you in advance roughly how long that will be so you can plan around it — particularly important if you work from home or have anything that cannot lose power.
More detail on this service is on the main Fuse Box / Consumer Unit Installation page, and everything we cover locally is listed on the Enfield area page.
Our own photography
Recent work
Call us
Speak to an electrician
Describe the fault or the job and we will tell you what is involved.
Keep exploring
Where to next
- All electrical services Installation, repairs, CCTV, fire alarms, lighting, EV charging and consumer units.
- Guides and advice Fifty practical articles for homeowners, landlords and businesses.
- Frequently asked questions Straight answers to the questions we are asked most often.
- Project gallery Examples of the work, by type.